Here, I’ll show you how to run troubleshooter. To fix it, you can try to run the troubleshooter to fix hardware issues or directly uninstall the storage controller. If your disk is failed or the storage controller on your main board is corrupted, you will receive the following error. If it’s correct, your flash drive may be broken and probably needs to be replaced. If it’s a flash drive, you need to confirm its drive letter first. If you use CMD to access CD/DVD drive that does not have media inside or a card reader that does not have a card in it, you will receive this error. ► CMD error - the device is not ready on CD/USB drive Type sfc /scannow in the window and hit Enter. Open the command prompt and run as administrator. If you think the system file is corrupted or damaged, you can try SFC Scannow command. ► SFC Scannow to fix the device is not ready Replace G: with the correct drive letter in your case. Type chkdsk G:/f in the command prompt and hit Enter to run it. Type cmd in the search box, right click it and select Run as administrator. Click Scan and repair drive and then restart your computer to make the changes available. Click the Tools tab and Check option under the Error checking section. Right click the drive that with file system error or bad sectors and select Properties. ✔ CHKDSK utility to fix the device is not ready ► The device is not ready because of file system error Windows will attempt to re-install the driver. Keep your device connected and restart the PC. Find out the device that is not ready, right-click the device and select Uninstall. Type device manager in the search box, right-click it and select Open. If the device driver is not installed, corrupted or missing, you will receive the warning message as well. If the error disappears, it implies that the device is damaged and the problem is caused by a damaged USB port. Plug the device out and plug it into a different computer. If the error disappears, that means the previous USB port is damaged. Plug out the device and plug it into a different port on the same computer. If the error disappears, that’s a connection issue. Plug out the device and plug it into the same port. It’s one of the reasons why you receive NOT READY ERROR. If you receive the error on external hard drive, you can try to check the connection issue with the following steps. ✔ Re-connect the drive to different USB port ► The device is not ready on external hard drive The device is not ready in Disk Management.CMD error - the device is not ready on CD/USB drive. SFC Scannow to fix the device is not ready.The device is not ready because of file system error.The device is not ready on external hard drive.How do I fix the device is not ready in Windows 7/8/10/11? In Disk Management, the device with file system error is marked as raw format. Compatibility issue between the computer and external digital device.The external storage device is not well connected, like the device is loosely connected to the computer, the connector is broken, or USB port is damaged.Here, I’ll show you the common reasons in the following: This error is caused by different reasons. “The device is not ready” error may occur when you attempt to access data from hard drive, USB flash drive, pen drive, DVD drive, SD card, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |